AutoCAD Plant 3D 2011 Concise Guide (5 )
 

Chapter ,Womens Lacoste Trainers New
create devices
creating the device,Lacoste Tennis Trainers, we first opened the shop two doors on the wall,Lacoste UK, size of 2100X900.
first ucs positioning in the corner as shown below:
input ucs Enter
specify the origin of UCS or [Face (F) / label (NA) / object (OB) / before (P) / view (V) / the World (W) / X / Y / Z / Z-axis (ZA )]
(specify the corner with the occupy point for the origin)
specified X axis points,Womens Lacoste Carnaby Trainers, or : Direct Enter

then create rectangular, used to grow two rectangular beginnings, rectangular lofty of 900 W 450 2100
Click Modeling
rectangular

Select the first corner
specify the first corner or [Center (C)]: -450,1000 (shake in opposite directions to the x 450mm, y intention 1000mm)
specify a corner or [Cube (C) / width (L)]: l (with the length of the access)
specified length :
specified width :
specified altitude or [2 (2P)] :
and then copy a
as shown

command with the feud set by deducting the doorway

results obtained are as with:

then create the devices.
There are 3 ways to create devices
:
first direct use of the built-in equipment
second appliance with a built-in horizontal and perpendicular prototype institution device
The third model
build their own devices.
introduced here in front of 2, the third and mart the same way you created earlier.
5.1 to create built-in device
structured to graphics, we also built to create a file because the device.
That alternative in project treatment
vegetation 3D graphics, built right-click to create new graphics.


we named the current graphics: equipment. dwg


characteristic creation method:
Ribbon>


here first create a new pump.


be discerned from the above there are numerous preset device, here we choose the centrifugal pump.
as below:

annoying is namely meantime we use the metric system, in theory, namely apt use mm, elements should be the size accustomed here, or inches. So we put them to alteration my own: 1 inch = 1 inch = 2.539999918 cm = 25.4mm
later conversion as:

, however modified, still merely inches Nozzle, servant or not use, do not know the official national criterion library are good, look after the download.
changes had perished after the nozzle, so back to the elemental inch style.

change it back, we amplified at a certain percent. Back to see after:

nozzle can modify the line click on the size, type

5.2 Create the built model equipment
as above yet this period select the container to establish a horizontal tank Horizontal Vessel.

ashore the chart using a dished brain, we can choose to delete, and then changed to oval-shaped head, as shown under

then retention it after the export example

After
placed on the map:

can add a new nozzle
culling of equipment, click on the pen-like nozzle position can be modified to add as shown

point is, first select the nozzle, and then point pen can be changed, all press. Do not twice click, or lightly select the equipment, but not to the nozzles.
that is, first select this, then select pen, while there is ok when editing a nozzle.


tin choose the table to increase, erase, adjust the necessitated nozzle, and here we changed the location of the nozzle, the change after following chart:

equipment to add the better.

return to the main catalogue