As long for tread 7 , you tin reinstate the 6 face

First, crack Cube, we must first understand its architecture, 6-color 6-sided cube, each side is divided into the chief block (the middle of the block 6), corners (4 corner blocks 8) and the side blocks (four at the edge of the block 12). Of which only one side the central block, they are a nailed structure,GHD Blue Straighteners, so central is the ruddy block, then the red should be the other side to this converge. And red is always the heart of the block opposite the central block of orange (worldwide standard is so specified). The block has 2 side faces 2 colors, corners there are three faces three colors.

Next we have with every side characterized by the letter,

sina and then wreck to unravel in the letter will be accustom to swivel a wafer or a surface, and direction: case in point: R (on benefit of 90 degrees clockwise ashore the right), R `(aboard behalf of the right turn 90 degrees counterclockwise), R2 (2 periods on behalf of the right turn 90 degrees clockwise)
is shown below:

terminal note is: the label of each side is relating, for instance, F is the front, that is, while holding a Rubik's cube because his side,GHD Classic Straighteners, if we imitate the rotation to the other side, then there is a new side of a front.

Well, let's try the next
the following 7 steps to reinstate the cube it!

1. 1st side of the medium of the stop is white (with a piece of rubiks logo) facing the top, and then make a white cross at the top, namely namely,GHD MK4 Pure Straighteners, all other colors of the blocks to the fitting position (small complex, see picture, note the subject of the on formulas Oh, did correct)

2. Then the pearly edges homing (Cheats said,GHD IV Straighteners, very complex and easier to know, alternatively plug-Rights)

3. Then let the middle edge pieces into place.
the white face turned to the next, find the red and green side of the block, if the red and green on the top side of the block according top clockwise until the edge of the block in Figure 1 on the same position, in accordance with the formulas rotating cube, so that side of the block into place. If the red and green side of the block in the middle of a layer, yet in the wrong place or color peccadillo, the first block on the right side of the red and green position in front, and then re-spin in accordance with one of the following sequence 1.


4. Then the top (ought be yellow) side of the block to adjust ascent, making yellow cross. If the rotation in accordance with formulas 1, the top no a yellow cross, repeatable formulas by turning, until the yellow cross appears.

5. Then adjusted to cross the yellow approximately corners,GHD Green Butterfly 2011, a bit complicated to see formulas clue.

6. Usually this time yellow block, and the dislocation will have the color of the side, along to formulas (I have not entirely digested) to situate the four corners of the yellow block.

7. Finally, the edge of the color and then adjust to the corresponding location. You're done! ,GHD IV Dark Straighteners! Thrill.